Eyebrow Roof Kit – Standing Seam

From: $34.48 sq. in.

Copper Standing Seam Eyebrow Roof Kit. 16oz Bright Copper. Double rolled seams are 1″ tall and 14 3/4″ on center.

To order: Measure the roof WIDTH at the eave and it’s DEPTH along the slope from the eave to the wall. See the Measuring Guide to the left.

Select the Face Flange Height desired for the drip edge and enter the WIDTH in inches, fractions as decimals.

Enter the WIDTH again for the Seam Closers and the Apron.

If the roof abuts brick, enter the WIDTH for the Brick Flashing. When ordering Brick Counter Flashing, Select the flashing height necessary. To determine this, measure from the roof deck up the brick to the mortar joint you’ll be installing the Counter Flashing into. Subtract an inch (for the seam height) and select the next lowest even number. For example: If you measure 5 3/8″ from roof deck to mortar joint, select 4″ Flashing Height and enter the roof Width.

If the roof is to be installed below manufactured stone, enter the WIDTH for the Manufactured Stone Flashing. Select “N/A” if installing under siding or abutting brick. No counter flashing is necessary for installation under siding.

Approximately 100 Nails and Hold Down Clips are necessary for each 100 square feet of roof. Most eyebrow roofs will require only one pack of each.

Hand Seamers can be used to close the seams, but we provide a “lender” installation tool kit containing all tools make installation easier. A Flashing Tool Kit is also available.

Finally, at the bottom of this page, enter the WIDTH and DEPTH of the roof plane in inches, fractions as decimals.

The total price will be displayed in the Shopping Cart.

Free 48 State Shipping.